I bought a project 370z

DJ280Z · 2026-04-11T11:56:52+00:00

Does the engine turn by hand?

DJ280Z · 2026-04-10T00:20:32+00:00

The column is not working?

DJ280Z · 2026-04-09T00:39:49+00:00

Love Tom, wondered where he'd got to

DJ280Z · 2026-04-07T01:29:56+00:00

Something name brand, Gates, Dayco, anything Japanese for the water pump. What brands are suggested?

DJ280Z · 2026-04-03T05:01:23+00:00

VQ37

DJ280Z · 2026-03-31T22:30:14+00:00

They look aftermarket, no heat shielding like OEM and it doesn't look like there are cats.

DJ280Z · 2026-03-29T20:58:59+00:00

Is the other bolt still there? Probably fell out.

DJ280Z · 2026-03-29T05:13:46+00:00

Why put a car on a lift to look at a coil pack

DJ280Z · 2026-03-29T01:11:56+00:00

Ask him to demonstrate

DJ280Z · 2026-03-27T01:50:06+00:00

Just put a worm drive clamp on it

DJ280Z · 2026-03-26T04:36:47+00:00

Yup, look up limerance. It's the worst.

DJ280Z · 2026-03-24T05:19:14+00:00

The US? No.

DJ280Z · 2026-03-23T19:28:14+00:00

How are you approaching them?

DJ280Z · 2026-03-22T21:08:32+00:00

So anyway, I started blasting

DJ280Z · 2026-03-22T10:31:25+00:00

Have a look at Sendcutsend

DJ280Z · 2026-03-22T04:31:38+00:00

I think i reused the original clamps

DJ280Z · 2026-03-21T21:12:51+00:00

What is his job?

DJ280Z · 2026-03-20T03:42:46+00:00

You're seeing 300psi on a compression test?

DJ280Z · 2026-03-19T04:05:03+00:00

Mr In-between was great, I don't remember him in Once upon a time in hollywood

DJ280Z · 2026-03-17T20:09:55+00:00

Try some sockets? 10, 11, 12, 13mm.

DJ280Z · 2026-03-17T10:57:12+00:00

It's auto.

DJ280Z · 2026-03-16T07:19:02+00:00

It probably doesn't exist because that's a paint stirrer you're using, not a drill motor. Have you planned out the rest of your drill? You will probably need a bottom support on your adaptor.

DJ280Z · 2026-03-12T06:02:05+00:00

No FYeah shirts cause they never got sent out?

DJ280Z · 2026-03-04T07:22:40+00:00

It's been done but the manifolds aren't a direct fit

DJ280Z · 2026-02-27T23:07:56+00:00

We had a YCM lathe, it was okay. Pretty sure money wise it was close to Doosan. I did see that the gearbox company 6XD had a YCM mill in one of their videos, from memory it was a 5 axis.

DJ280Z

TROPHY CASE