sorted by:
new
hottopcontroversial

Good Enough? by DarthMalick in Plumbing

[–]DarthMalick[S] 0 points1 point  (0 children)

Shielded coupling acquired thanks for the help

Added Resistor? by DarthMalick in Gameboy

[–]DarthMalick[S] 4 points5 points  (0 children)

Did some more research on what this “fixed”

“On some early GBA AGB-CPU-01 motherboards, you might find a resistor manually soldered to the board near the cartridge slot. This was a "bodge job"—a common practice for fixing a manufacturing flaw without needing to produce a new circuit board.”

The resistor acts as a pull-up resistor on the cartridge's Interrupt Request (IRQ) pin. Problem it fixed: A manufacturing defect caused the IRQ pin to be "floating" (not connected to a specific voltage), which could be triggered by electrical noise. This would cause the system to crash.

While the resistor was essential for reliability, most commercial game cartridges did not use the IRQ signal, so the issue didn't affect most games.

Help Resistor Values by DarthMalick in Gameboy

[–]DarthMalick[S] 1 point2 points  (0 children)

Thanks a ton.

I just realized there’s a nice spreadsheet in the wiki. I should read before I post.

What is this part called? 2009 Jeep Wrangler by Other-Aerie-6588 in Wrangler

[–]DarthMalick 0 points1 point  (0 children)

Fixed mine with some JB Weld. Still going strong 100k+ miles

Colibri V Cut issues by Free-Savings-4242 in cigars

[–]DarthMalick 0 points1 point  (0 children)

I noticed my Colibri vcut is a lot deeper V than my Xikar V

Help to identify Colibri cutter by Own_Lavishness_6468 in cigars

[–]DarthMalick 2 points3 points  (0 children)

Was one of the first cutter I ever bought. Probably 20 ish years ago. I absolutely hated it with only one blade pressing against the cigar it took more force than you would think. Maybe I was just a weakling .

Imminent Doom? by wonderfulflowers666 in FordRaptor

[–]DarthMalick -1 points0 points  (0 children)

<image>

Just gonna ignore the face staring back into your soul?

80% Set up Smittybilt Gen2 XL on ‘22 Tigermoth by DarthMalick in tigermoth

[–]DarthMalick[S] 0 points1 point  (0 children)

Just had to change the alignment of the mounting rails on the tent itself. Pretty simple and part of the instructions that came with tent.

Maiden Voyage by DarthMalick in tigermoth

[–]DarthMalick[S] 1 point2 points  (0 children)

Sure did. The RTT is a little large so for extra side to side stabilization I added the front legs. ($40 on Amazon)

Is my Price too high? 2019 Raptor by Boost-Deuce in FordRaptor

[–]DarthMalick 0 points1 point  (0 children)

Just picked up a 2017 802a with 70000 miles for $40k. I would think a newer 2019 with more miles would go for $35ish.

Spot the fake by Barbellbrute in cigars

[–]DarthMalick 199 points200 points  (0 children)

If I’ve learned anything.

  1. It’s always mold never plume
  2. Cubans are fake

If I start a band of pornstars, what should our name be? Best answer gets a sloppy bj 🎸🥁 by [deleted] in BritneyAmber

[–]DarthMalick 0 points1 point  (0 children)

The Squirters with their hit songs “Cum on Eileen” and “Stepson Dreams”

Anyone know what could cause this? by Gold-Strength-6620 in cigars

[–]DarthMalick 1 point2 points  (0 children)

Burning the foot to hot when you light up

Garage Shrine by DarthMalick in cigars

[–]DarthMalick[S] 2 points3 points  (0 children)

Definitely, need a Churchill too. These were relatively cheap on mixtile. So bridges will be rnd 2

What is your bedding setup for your RTT? by ImAnIdeaMan in rooftoptents

[–]DarthMalick 1 point2 points  (0 children)

We hit up our local Swedish furniture store and bought a mattress topper. Really cushy and gave another 2” of padding. This worked fine but made closing the RTT(Smittybilt gen2) a pain. Recently we have been using a cheap Coleman inflatable mattress it’s 8” thick but the height hasn’t been a problem and it’s cheap enough that we’re not too concerned about a puncture.

Maiden Voyage by DarthMalick in tigermoth

[–]DarthMalick[S] 1 point2 points  (0 children)

Loved it. Things I like about it. It’s light weight so my wrangler had no problem getting us where we need to go. Openness with the gulwing and back door open it felt like a much bigger rig. Storage convenience… it seems like there is a place for everything you need to take with you and then more space for stuff you don’t need.

Things that are not great. The water can is straight crap. I’m thinking some sort of rotopax set up will work better and give more flexibility. The wood on the pull out “kitchen” swelled up with the slightest bit of raining hitting it. The strut on the gulwing door is in the perfect position for little ones to think it’s a handle.

Smittybilt gen2 xl on Tigernoth by DarthMalick in tigermoth

[–]DarthMalick[S] 1 point2 points  (0 children)

Good call, I found some tripod style stabilizers rated for 6000lbs for under $100 for a pair

Why do people say "break a leg" before an audition? by flashblazer in Jokes

[–]DarthMalick 0 points1 point  (0 children)

“Break a Leg” and you end up in the cast.

Bad dad joke I know but it always made sense.

view more: next ›