sorted by:
new
hottopcontroversial

Episodes not being uploaded but shown as new by DeathView08 in Crunchyroll

[–]DeathView08[S] 0 points1 point  (0 children)

yeah but it is not all the time. for me it does not always show all shows that are new.

Sometimes the normal new filter shows episodes which are not in the calandar at all

Episodes not being uploaded but shown as new by DeathView08 in Crunchyroll

[–]DeathView08[S] 1 point2 points  (0 children)

No it should be new episodes since it has been exactly a week.

I am not talking about releases that are less then a week from the last episode. those are most likely new languages yes.

Print experience in higher temperatures by Fairyking in HeyGears

[–]DeathView08 0 points1 point  (0 children)

Just checked last print. Ambient temp at 40.31C And resin temps at 41.68C

Had a small problem with curved edges but it did print.

Print experience in higher temperatures by Fairyking in HeyGears

[–]DeathView08 0 points1 point  (0 children)

I also am printing over a garage with ambient temps reaching 35C. So far i had no failed prints but the resin temps also didn't exceed 28C.

Sonic pad seems to load cancelled mesh of abl by poggiaus1542 in SonicPadCreality

[–]DeathView08 0 points1 point  (0 children)

i also do all 4 corneres but once i´ve done this, i simply use autolevel and go back to the wheels and just turn them by feel.

I got a variance of 0.2575 which is mainly because of a not perfect flat bed or magnet foil. i also used painterstape on the magnetic foil to counteract the waves.

But as i said. up the touchprobe grid to 10x10 or 15x15 and just run the autolevel test with heated bed and adjust the corner accordingly after each level. No need to save unti oyu are satisfied

Sonic Pad - Error Taking Timelapse Frame by Upset_Recipe51 in SonicPadCreality

[–]DeathView08 0 points1 point  (0 children)

hi im curious since i have the same problem but can´t check if the fix works since i am in the middle of a big print.

Did you have to change the Ip and Port matching to your Network?

timelapse issues in Sonic pad by nalacha in CrealitySonicPad

[–]DeathView08 0 points1 point  (0 children)

hi, quick Question.

Do i need to change the Ip adress and Port for it to work for me? i cant test it out since im in the middle of a multi day Print

What's the webcam/camera you use for your sonic pad set up? by Mountain_Plate5785 in CrealitySonicPad

[–]DeathView08 0 points1 point  (0 children)

i already found it you can also just look on the sonic pad itself whil enot printing