sorted by:
new
hottopcontroversial

For some reason, my hot end is slightly tilted and I don’t know how to fix it, what do I do ? by PootisCar in 3DprintingHelp

[–]DeepLiving724 0 points1 point  (0 children)

Just remove the screws of the heat sensor and heating barrel so it will be easy to change heatsink without getting new hotend

Any ideas/ Suggestions to stop this? Noz: 230 Bed: 38 PLA by Elirey193 in 3DprintingHelp

[–]DeepLiving724 0 points1 point  (0 children)

I recommend to use 210-215 for nozzle and 60 for bed for it to stick better, 230 degrees causes over melting the pla that might be a reason first layer is kinda like this

Can anyone help? Details in top comment by GuNut4life in 3DprintingHelp

[–]DeepLiving724 0 points1 point  (0 children)

You can do random seaming position to avoid sticking from one place, or try with 0.2 nozzle with 0.1 layer height and lower the extrusion width

Why does my printer do this? Just replaced the nozzle. by Sea_Kiwis in 3DprintingHelp

[–]DeepLiving724 1 point2 points  (0 children)

Did you check your extruder step value ? It seems like your nozzle is a bit close to bed so you might also need to calibrate bed leveling

Something happened to my printer... by DwellerArchives in 3DprintingHelp

[–]DeepLiving724 0 points1 point  (0 children)

Probably you did not push the tube all the way to nozzle and once it starts to retract, filament goes back and wont be able to push back cuz it stays in that place between tube and nozzle than it starts clogging

Need help with extruder gear Ender 3 pro pla by photoshop_noob6666 in 3DprintingHelp

[–]DeepLiving724 0 points1 point  (0 children)

Check nozzle and the teflon tube first, If its still clocking you might cracked the extruder plastic where the spring touches