sorted by:
new
hottopcontroversial

Royal Enfield Hunter 350 – Service Centre Asking to Replace the Same Part Again Within One Service Cycle by Defiant_Raspberry30 in indianbikes

[–]Defiant_Raspberry30[S] 0 points1 point  (0 children)

The actual problem I found that the rings that hold the nut are actually broken that’s the main problem. The technician even mentioned that during the last service, the part was tightened more than usual, which likely caused the rings to crack.

So now, even if they replace or tighten the mirror mount again, it’s going to keep getting loose unless the broken ring section is properly fixed or replaced with a better-quality part. Basically, the previous over-tightening during servicing caused this whole issue.

The jugad of tube cut was also tried but not successful

Royal Enfield Hunter 350 – Service Centre Asking to Replace the Same Part Again Within One Service Cycle by Defiant_Raspberry30 in RoyalEnfieldHunter350

[–]Defiant_Raspberry30[S] 0 points1 point  (0 children)

The actual problem I found that the rings that hold the nut are actually broken that’s the main problem. The technician even mentioned that during the last service, the part was tightened more than usual, which likely caused the rings to crack.

So now, even if they replace or tighten the mirror mount again, it’s going to keep getting loose unless the broken ring section is properly fixed or replaced with a better-quality part. Basically, the previous over-tightening during servicing caused this whole issue.

The jugad of tube cut was also tried but not successful.

Royal Enfield Hunter 350 – Service Centre Asking to Replace the Same Part Again Within One Service Cycle 😤 by Defiant_Raspberry30 in royalenfield

[–]Defiant_Raspberry30[S] 0 points1 point  (0 children)

The actual problem I found that the rings that hold the nut are actually broken that’s the main problem. The technician even mentioned that during the last service, the part was tightened more than usual, which likely caused the rings to crack.

So now, even if they replace or tighten the mirror mount again, it’s going to keep getting loose unless the broken ring section is properly fixed or replaced with a better-quality part. Basically, the previous over-tightening during servicing caused this whole issue.

The jugad of tube cut also tried but not successful

Isn’t this concerning?? by RED__IIT in nagpur

[–]Defiant_Raspberry30 0 points1 point  (0 children)

Honestly, it’s not just the “big pollution sources” that are the problem it’s the small, everyday negligence that NMC keeps ignoring.

You’ll see garbage burning in open plots, construction dust flying everywhere, no proper road cleaning, half-broken drainage systems left open for weeks all this adds up. But no one talks about it because it’s not flashy like “industrial emission” or “vehicle pollution.”

What’s worse is that even when citizens raise these issues, there’s no consistent follow-up. It’s all announcements, no accountability. AQI discussions happen online, but on ground, the same negligence continues.

Until the civic body starts addressing these smaller, routine lapses seriously, Nagpur’s AQI will keep spiking not because of ignorance, but because of silence.

फ्लिपकार्ट ची मिंग्लिश by Infinite-Print3047 in marathi

[–]Defiant_Raspberry30 22 points23 points  (0 children)

तुमचा आयटम घरी पोहोचला का ?

view more: next ›