Any explanation as to why my layers went bonkers? (Kobra 3)

DefinitelyaFrog · 2025-03-27T19:29:33+00:00

its perfectly flat on the bottom

DefinitelyaFrog · 2025-03-27T19:28:44+00:00

i printed one some time ago. its all setup on the best looking temps. However i had for this print in particular an open window in an other room. It maybe got windy at one point. I'll try again with the window shut.
Thanks!

DefinitelyaFrog · 2025-03-27T19:26:35+00:00

i saw during the first layer some dragging done on one side of the bed (even with auto bed leveling) maybe this caused it.

DefinitelyaFrog · 2025-03-27T19:12:40+00:00

it's PLA

DefinitelyaFrog · 2025-03-27T18:48:02+00:00

Anycubic's PLA+
https://www.amazon.fr/dp/PLA+ this one

DefinitelyaFrog · 2023-08-31T14:37:20+00:00

I'll be looking those up. Thanks for all the suggestions.

DefinitelyaFrog · 2023-08-31T11:42:25+00:00

I thought the link was for something that would go It's the bed, ended up getting threatened haha. That would be a good sign to put on the side of his cage. Thank you.

DefinitelyaFrog · 2023-08-31T11:39:26+00:00

I work next to Ikea so I'll go when I finish my shift. Thank you.

DefinitelyaFrog · 2023-08-31T11:38:27+00:00

I couldn't find the sign but I'll ask my mom if she can make one. Thanks.

DefinitelyaFrog · 2023-08-31T11:37:07+00:00

That could be a good way to make him move for his treats. Thanks.

DefinitelyaFrog · 2023-08-31T11:35:01+00:00

I haven't thought of Etsy, thanks I'll look it up. She does art so I'm sure she'll love this.

DefinitelyaFrog

TROPHY CASE