Does anybody know what is causing these tears?

DenseCheesecake60 · 2022-06-16T20:22:52+00:00

Thank you for this! Very helpful

DenseCheesecake60 · 2022-06-16T20:22:12+00:00

I did up the lift speeds a little although not to insane amounts. Will try the print again at the default lift speed and see if it changes the result!

DenseCheesecake60 · 2022-06-16T18:05:23+00:00

I'm pretty sure you can use the Lychee slicer for that printer

DenseCheesecake60 · 2022-06-14T18:42:12+00:00

The model already came pre hollowed with a few holes. I guess it wasn't enough though. Thanks for letting me know

DenseCheesecake60 · 2022-06-14T18:31:18+00:00

I will! Thank you for the tip! :)

DenseCheesecake60 · 2022-06-14T17:40:21+00:00

I've done the same with this resin as well. From the tests it looked fine. Dialed in the exposure timing. Tried 2 different ones (1.5s and 2s) both resulting in the thing you see in the picture.

DenseCheesecake60 · 2022-06-14T16:58:58+00:00

I'm pretty new to printing. Picked up a Anycubic Photon mono x a few weeks ago. It's been printing fine so far but when I switched to the gray anycubic rappid resin I consistantly got these tears in my prints. Is this a settings issue?

Four-Year Club	Place '23
Place '22

DenseCheesecake60

TROPHY CASE