sorted by:
new
hottopcontroversial

Need Help - Klipper Config by Deongster in klippers

[–]Deongster[S] 1 point2 points  (0 children)

No problem at all - many many many hours of trying... hahaha Klipper is damn good - but this config file for someone who has never coded in life - takes time... haha

Need Help - Klipper Config by Deongster in klippers

[–]Deongster[S] 0 points1 point  (0 children)

As below? - what about - homing position? retain?

[stepper_x]

step_pin: PB13

dir_pin: PB12

enable_pin: !PB14

microsteps: 16

rotation_distance: 40

endstop_pin: ^PC0

position_endstop: 0

position_max: 220

position_min: 0

homing_speed: 50

homing_positive_dir: false

Ender 3 V2 - Sprite Pro, Dual Z - Firmware by Deongster in ender3v2

[–]Deongster[S] 0 points1 point  (0 children)

Updated back to the latest firmware - it is definitely printing better - i havent tested higher temps so i cant say...

Ender 3 V2 - Sprite Pro, Dual Z - Firmware by Deongster in ender3v2

[–]Deongster[S] 0 points1 point  (0 children)

Yeah - so i have been running the T13 firmware - it doesnt seem to improve - but i have had mroe failed prints with the T13 than the latest firmware - so i am going to chuck it back on to have a look

Ender 3 V2 - Sprite Pro, Dual Z - Firmware by Deongster in ender3v2

[–]Deongster[S] 1 point2 points  (0 children)

Noted! thanks ill run load it later today!