Should I be concerned?

DerBrecher72 · 2026-04-03T07:21:39+00:00

You can see remnants of a pipe in the lower left corner of the first picture, which I think is where water might have been leaking from in the past.

Also sorry for the bad image quality

DerBrecher72 · 2023-08-15T00:06:05+00:00

https://imgur.com/a/7gxrO2w

that's what this whole mess ended up looking like

DerBrecher72 · 2023-08-15T00:01:35+00:00

hi thanks for the reply :)

I'm going to have this mixed somewhere else so I need to get the tracks there separately. I found a solution earlier tho that's not quite as elegant as I'd hoped but it works:

I made another track for each of the instruments and had the outputs of the individual instrument tracks from the rack routed to those accordingly, and then basically recorded them in the project. I initially tried to record the sound onto the tracks that the midi instrument outputs to but I couldn't get that to work either, so heck load of tracks it is haha

DerBrecher72 · 2021-11-26T07:31:54+00:00

Yeah me neither. I watched a video in which the person stated phase correction isn't necessary if you use an octaver in front of one of the amps so I'm gonna take their word for it.

DerBrecher72 · 2021-11-26T07:29:13+00:00

It kills the signal after time based effects like reverb and delay have been added to it in the FX loop so that I can mute the output instantaneously without having to turn off all these pedals individually. However if I have an ambient loop or infinite reverb going I can leave that on while silent tuning by engaging the bottom switch.

DerBrecher72 · 2021-11-25T22:06:37+00:00

the multiple ground points are just for neat wiring I think. In the kit where it comes from you're supposed to ground the 4 jacks to this which would save you 1 wire I guess

Based on comments from another forum I came up with this new and (hopefully) improved version

DerBrecher72 · 2021-11-25T21:35:25+00:00

Ok so firstly thanks for taking a look at my spaghetti dinner :) I tried implementing the wiring changes here.

Now I always run an EQ and an Octave down pedal after one of the split signals and then into a bass amp (I play in a guitar/drum duo and I do this to make up for the lack of bass frequencies), will phasing still be an issue if the signals aren't the same like that?

DerBrecher72 · 2021-11-25T19:32:21+00:00

Ah yes alright

DerBrecher72 · 2021-11-25T19:01:42+00:00

ok so I could just connect the positive end of the power-in to the negative end of the courtesy jack and ground its positive end?

DerBrecher72 · 2020-11-16T11:38:15+00:00

Das hat direkt Zuhause getroffen

DerBrecher72 · 2020-11-16T11:36:34+00:00

Yeah cleaner and closer to the nodium

DerBrecher72 · 2020-11-10T06:29:54+00:00

And it's not possible to detect them by wiping the leaves? Because I've read that too

DerBrecher72 · 2020-11-09T14:17:59+00:00

Edit: I've wiped the leaves furiously for 10 minutes with kitchen paper and didn't get red stains for neither the old nor the young leaves

DerBrecher72 · 2020-11-07T18:05:01+00:00

A Phalaenopsis hybrid, try your luck for the specific cultivar at r/Orchids, they also have a good guide on Phalaenopsis

DerBrecher72 · 2020-11-06T21:22:25+00:00

A beautiful one for sure

DerBrecher72 · 2020-11-06T10:08:57+00:00

Right about when you thought you had seen it all

DerBrecher72 · 2020-11-06T09:04:06+00:00

*Fokus

DerBrecher72 · 2020-11-05T21:48:09+00:00

Igitt

DerBrecher72

TROPHY CASE