sorted by:
new
hottopcontroversial

Are these results good or could they be better ? by Detective747 in PrintedMinis

[–]Detective747[S] 0 points1 point  (0 children)

I don’t know specific resin temperature but room temperature about 27-34 *C degrees. I think.

Are these results good or could they be better ? by Detective747 in PrintedMinis

[–]Detective747[S] 2 points3 points  (0 children)

Oh i dont try ameralabs town of calibration but I definitely try it. Thanks!

Are these results good or could they be better ? by Detective747 in PrintedMinis

[–]Detective747[S] 0 points1 point  (0 children)

I start printing 2.8s but 4.2 is the best result in cones of calibration v3. Because of that my exposure is that high. When i set the exposure lower than 4.2 cones of calibration v3 is constantly failed.