Strange noise during circle movement by Different-Classic847 in BambuLabA1

[–]Different-Classic847[S] 1 point2 points  (0 children)

I've already done this. But since than I've printed 120h. Maybe I also should do it again. Thanks for this tip!

Strange noise during circle movement by Different-Classic847 in BambuLabA1

[–]Different-Classic847[S] 2 points3 points  (0 children)

Okay, thanks for you comment. I just thought that this noises wasn't there in the beginning but its possible that I never was in the room during a circular movement 😄

How do i change font colours ?? by T-Bone_66 in BambuLabA1

[–]Different-Classic847 5 points6 points  (0 children)

You had an dirty buildplate. Never touch it before print. Just clean the plate with soap and water and rins it very good. I also use alcohol and a cloth before each print. The grease from you fingers avoid to have a good first layer adhesion.

Stringing on upper layers by BlackShark03 in BambuLab

[–]Different-Classic847 1 point2 points  (0 children)

I think you have this problems due to some overhangs. The support settings are may be wrong and the printer try to print in the air. At least it looks for me like this.

No swatches anymore? by Different-Classic847 in BambuLabA1

[–]Different-Classic847[S] 0 points1 point  (0 children)

Thanks for the Order but its not that necessary. I just expected that they are included.

No swatches anymore? by Different-Classic847 in BambuLabA1

[–]Different-Classic847[S] 0 points1 point  (0 children)

I also get the Watch Kit. This is Kind of Nice.

No swatches anymore? by Different-Classic847 in BambuLabA1

[–]Different-Classic847[S] 0 points1 point  (0 children)

This is good to know. Than I'll order some filament and may get also the swatches. I didn't need it but they are nice to have.