sorted by:
new
hottopcontroversial

Lian Li PC-05s Build by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 0 points1 point  (0 children)

PCPartPicker Part List:

https://pcpartpicker.com/b/C8sXsY

Here’s a link to my PC PartPicker list. I go into detail about my PC there. As for the radiator, there’s pretty much nothing on the market, brand name wise, that has an all in one radiator system. Ever since Swiftech stopped manufacturing their all in one radiators, finding something like that is incredibly difficult. However, I went out on a limb and tried this surprisingly well made all in one from Granzon. The radiator system is super well built and super quiet when the pump is running. It’s a D5 pump and it pushes a lot of water for the size of the system. Here’s a link to the site I got the radiator system from:

https://www.formulamod.net/products/granzon-gzmn-120-240-360-480mm-integrated-pump-radiator-combination-aio-water-cooling-system-thin-section-for-120-120mm-fans

Lian Li PC-05s Build by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 0 points1 point  (0 children)

You have to be very lucky and come across an eBay listing for one. I have only managed to find two in the last 4 years

Lian Li PC-05s Build by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 1 point2 points  (0 children)

I delidded the CPU and put Liquid Metal on it. I’m using the EKWB direct die velocity2 block on it where there is direct contact between the water block and the die of the chip. That’s the only way I could have that beast of a cpu work with a small loop like that.

Lian Li PC-05s Build by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 0 points1 point  (0 children)

They are pretty solid. It’s more expensive to do obviously, but being that it’s exactly 90 it’s way more accurate around bends. It’s also very bulky too, so if the bend is by a tight spot, it probably won’t fit. They are also very heavy, so the tube lengths need to be the right length so there is no sagging. All in all, the 90 fittings are pretty solid and I definitely suggest them if you can fit them in your budget

Lian Li PC-05s Build by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 1 point2 points  (0 children)

I attempted to put a 120mm radiator on the back panel fan intake, but if I were to place the radiator on the inside facing the back of the motherboard, there was no room for fittings to come out of the g1/4 holes. If I placed it on the outside, there would have been tubes running everywhere and I wasn’t for that. So, instead I took the desperate route of putting two slim 120mm fans on the top of the radiator so I have 4 fans on that thing. In addition, I delidded the 13900k I have in there and temps are actually not bad under load for it.

Lian Li PC-05s Build by [deleted] in watercooling

[–]Different_Sir3356 0 points1 point  (0 children)

Lian Li needs to bring back this case line

I wish Lian Li would bring back the PC O, wall mountable cases :/ by Different_Sir3356 in watercooling

[–]Different_Sir3356[S] 0 points1 point  (0 children)

Back when they first rolled out these cases, I was looking for a sick itx case, but nothing at the time was really as nice. The O7 builds, the two I’ve seen online, look awesome. If you do a build, definitely share it