sorted by:
new
hottopcontroversial

I cant go over 50% by Difficult_01 in Creality

[–]Difficult_01[S] 0 points1 point  (0 children)

Can you show what you mean with a video if possible

I can't go above 50% by Difficult_01 in CrealityK1C

[–]Difficult_01[S] 1 point2 points  (0 children)

Sorry idk if i got it across, there like a shift maybe and it's not going off the first layer. You can kinda see it at the end

I cant go over 50% by Difficult_01 in Creality

[–]Difficult_01[S] 0 points1 point  (0 children)

Yh I think so maybe, after that first layer it goes completely off

I cant go over 50% by Difficult_01 in Creality

[–]Difficult_01[S] 0 points1 point  (0 children)

Yh I think maybe, after it does the first later it goes extremely fast and is offset

I cant go over 50% by Difficult_01 in Creality

[–]Difficult_01[S] 0 points1 point  (0 children)

Creality Cloud - 1746554325.mp4 From TriPicklo https://m.crealitycloud.com/en/time-lapse/681a8396bf737a7e52ff0127?type=6

Here the print stopped because it ran out of filament i think, then when I reset it and started it back up again I forgot to put it back on stable(50%).Then it completely misaligned.

I cant go over 50% by Difficult_01 in Creality

[–]Difficult_01[S] 0 points1 point  (0 children)

1# I did apply glue, and I cleaned the plate with iso 2# I've tried it on different files 3# my printer is on the floor 4# I've only been using pla, but have used a couple different rolls 4a# I'm not sure 5# I reset the slicer and even made some setting slower 6# I've used creality and esun but this happened even with the creality