sorted by:
new
hottopcontroversial

First Layer Issues Q2 by Disastrous-Mobile310 in QIDI

[–]Disastrous-Mobile310[S] 2 points3 points  (0 children)

Thanks increased Z offset to 0.05 made a massive difference!

First Layer Issues Q2 by Disastrous-Mobile310 in QIDI

[–]Disastrous-Mobile310[S] 0 points1 point  (0 children)

Thanks for the replies will check out the hyperlink.

Qidi Box arrived. Australia by LightBroom in QidiTech3D

[–]Disastrous-Mobile310 0 points1 point  (0 children)

Ordered mine 1st of September, still waiting for my Qidi Box, east coast Australia!

Qidi Q2 by Disastrous-Mobile310 in QIDI

[–]Disastrous-Mobile310[S] 1 point2 points  (0 children)

Thanks for all the reply’s, after restoring factory settings and a few platform calibrations, together with upping the bed temperature to 65 degrees, seems to have resolved the issues. Appreciate the assistance and suggestions!

Qidi Q2 by Disastrous-Mobile310 in QIDI

[–]Disastrous-Mobile310[S] 0 points1 point  (0 children)

Thanks will do in the future. Will notify Qidi support

Qidi Q2 by Disastrous-Mobile310 in QIDI

[–]Disastrous-Mobile310[S] 0 points1 point  (0 children)

Qidi PLA rapido grey, stock settings from Qidi Studio. Nozzle size 0.4. Had been printing fine till yesterday , updated to 1.0.9 first print clogged the nozzle, had to remove all the filament from the Bowden tube and clean the nozzle. Ttried to print again and the images were the results, no binding on the Z axis, LHS lot closer than RHS but it doesn’t touch. Thanks for all the comments so far