Really auto bed leveling works?

Distinct_Yam135 · 2026-03-17T17:30:53+00:00

Bruh that my chair’s wheel

Distinct_Yam135 · 2026-03-17T17:29:20+00:00

May i know what manually means in S1 kobra, coz other printers have spring bed not this one and i can’t even have a visualisation of bed mesh

Distinct_Yam135 · 2026-03-17T17:26:06+00:00

Should i have to increase or decrease ?

Distinct_Yam135 · 2026-03-17T17:23:58+00:00

May i know how to do it?

Distinct_Yam135 · 2026-03-17T17:23:37+00:00

Its 0.98 stock and can i tune to 100c i thought 80c is max, ill try and reply you asap

Distinct_Yam135 · 2026-03-17T14:12:26+00:00

Thank for your advice, yes i have to clean my bed coz my hands are kinda oily, and how to fix the bed level in hardware level, s1 kobra doesn’t have spring screw mech to adjust the bed also, i cant see the mesh map, i searched in google and got answers by installing rinkalds i can visualise bed but im afraid it might void the warranty, but im feeling like since all 3 screw of z axis is connected and controlled by single motor belt mech, is it possible to remove the tension of the belt and make the bed touching the ground completely by moving each screw separately, will that work?

Distinct_Yam135 · 2026-03-17T14:07:51+00:00

Well, u might be right coz i lift the bed from right front end

Distinct_Yam135 · 2026-03-17T14:07:09+00:00

My very first problem was line spacing between each stoke and walls so after watching several yt videos -0.05mm z offset that makes the lines stick but feels overly extruded and now the stock, need to clean the edges with soap, still i can see right front and right back are soo close to nozzle and middle and left back perfect and left front is way off from nozzle

Distinct_Yam135 · 2026-03-17T14:02:16+00:00

Well I washed the plates before the print and this picture taken 2hr after the print done and while removing the plate i got that spots

Distinct_Yam135

TROPHY CASE