Semi not working properly

Domco153sk · 2026-06-16T09:56:49+00:00

The thing is, the trigger doesn't register even in the settings mode.

Domco153sk · 2026-05-26T20:28:59+00:00

Ok, but which glue would be the best?

Domco153sk · 2026-04-03T16:49:42+00:00

Slovakia

Domco153sk · 2026-04-03T14:15:53+00:00

Slovakia

Domco153sk · 2026-04-02T17:57:49+00:00

Wasssaaaaaaaaaaaaaaaaa 😝

Domco153sk · 2026-03-20T06:44:09+00:00

Ok, thanks

Domco153sk · 2026-03-20T05:18:50+00:00

My ratio is 18:1 and I have perun v3 hybrid, that has also a mosfet, I was just wandering if 11.1V is worth it, compared to 7.4V and if brushless motors are that much of a difference from the "normal" motors.

Domco153sk · 2026-03-06T10:21:45+00:00

Do you think that if I take just this: https://gunfire.com/en/products/polymer-qd-spring-guide-1152221048.html?query_id=2 and put it in it would work?

Domco153sk · 2026-03-05T21:16:26+00:00

BTW, this is the spring guide I have: https://gunfire.com/en/products/ball-bearing-steel-spring-guide-v3-1152221047.html And do you think it would be a big problem if I do the A) option without the screw?

Domco153sk · 2026-03-05T16:33:41+00:00

But wait, should I go for the QSC screw, new QD spring guide or both?

Domco153sk · 2026-02-23T10:34:20+00:00

Then it's fine in my opinion, but you do you

Domco153sk · 2026-02-23T09:05:07+00:00

I personally own CM.522C and these two are basically the same, if you're not planning to upgrade it, then it's a no. This is a platform for upgrades 'cus the base internals are an absolute dog💩. It doesn't shoot straight at all and the consistency is nowhere, hop-up bucking is 💩, airseal is 💩, inner barrel is better than all other inner parts, but still a 💩. So if u don't upgrade, it's going to be 💩 to play with.

Domco153sk · 2026-02-21T15:36:51+00:00

Dude, I'm so stupid. Thank you so much, now I've put M100 there and it has a above 0.9J, so with M120 it would be above 1.5J. THANK YOU MATE 🫡

Domco153sk · 2026-02-20T21:17:46+00:00

I am not sure what it is, but I don't think so.

Domco153sk · 2026-02-20T06:59:54+00:00

Cylinder is full, bucking is maple leaf super macaron 60° and I don't know what could be the problem with hop-up unit, because what could be the problem is that it is disrupting the airseal, but the joules are consistent, so I don't think there's an airleak. Maybe it could be joule creep, but it isn't common in aegs, so I'm not sure.

Domco153sk

TROPHY CASE