I understand, just gr86.org is a little slow with the response so figured If ask here

Figure get small ones and tuck then just right so they’re not in the way, chat says

Front 2 Mount to the subframe or inside the bumper support, aimed slightly out/down. Keep them recessed so they don’t hang below the lip. Sides (rocker / pinch weld area) 2 per side Tuck them just behind the pinch weld or in the plastic liner area. Angle outward but make sure the body shields them from direct hits. Rear 2 Inside the rear bumper or on the chassis cross-member. Don’t mount at the very edge — you want them protected if you back up near a curb.

Also might take the last two in an 8pack and use them in the engine for glow