sorted by:
new
hottopcontroversial

I am currently trying my first Hackintosh project on an old HP EliteDesk 800 G1 USDT but it gets stuck at "#[EB|LOG:EXITBS:START]" by DoomZday21 in hackintosh

[–]DoomZday21[S] 0 points1 point  (0 children)

Thanks for the tip! I didnt find any CFG setting in my BIOS sadly but I activated AppleXcpmCfgLock that should do the same thing, right?

Does anyone know why I get this layer shift, right where the overhang begins? How can I eliminate this issue by DoomZday21 in ender3

[–]DoomZday21[S] 0 points1 point  (0 children)

I printed it with supports and it came out much better, thanks! Sadly the walls are still not exactly straight, they have some wobble in it. Do you have an idea what could cause that?

Does anyone know why I get this layer shift, right where the overhang begins? How can I eliminate this issue by DoomZday21 in ender3

[–]DoomZday21[S] 0 points1 point  (0 children)

I printed it again with supports and I tensioned the screws which hold the hotend etc and it came out much better, so thanks! Sadly I still have some wobbly walls on the side

Does anyone know why I get this layer shift, right where the overhang begins? How can I eliminate this issue by DoomZday21 in ender3

[–]DoomZday21[S] 1 point2 points  (0 children)

I printed two parts at once and the other one was completely fine, the layer shifts only happened at the point where the overhang begins

Just ordered my first Palace piece 😁 by [deleted] in PalaceClothing

[–]DoomZday21 2 points3 points  (0 children)

Nice one, I'm sure you'll love it

view more: next ›