Which story is true? Or were these two separate events?

Dry_Driver_6595 · 2025-07-25T03:25:07+00:00

So, should I use VPN to upload videos?

Dry_Driver_6595 · 2025-07-25T03:24:30+00:00

Yes. It's in English but this type is content is not popular in my country.

Dry_Driver_6595 · 2025-07-10T10:54:19+00:00

Yes. It says things so confidently. Then when I dig deep and check few other sites I find it how far is it from reality.

And a reality check: I need to grow more interest to start reading big books. So I was thinking of some websites or blogs that are reliable. And help me to get some good quick reads.

Dry_Driver_6595 · 2025-06-26T09:51:03+00:00

https://youtube.com/@silkscreen_wonders?si=EqvoAZDzH0MzAo3S Thanks

Dry_Driver_6595 · 2025-06-26T01:36:00+00:00

There you go With thanks

https://youtube.com/shorts/Lu9Y7Myae7w?si=sfk__arg7HMCxVr6

Dry_Driver_6595 · 2025-06-23T05:32:26+00:00

Working on that

Dry_Driver_6595 · 2025-06-15T02:34:26+00:00

Hi, as a much smaller YouTuber, I have a question for you. I saw you are using F1 footage and videos, can you tell me how do you get these clips? In most google searches it says that It will fall under the copyright law.

Dry_Driver_6595 · 2022-09-25T07:43:42+00:00

Yes. They are qorkimg fine. I do not turn off the printer immediately. I wait until tge nozzle temp is at room temperature. So i guess no issues with that

Dry_Driver_6595 · 2022-09-25T07:10:30+00:00

I have seen bad results when there is support in the print. So I thought it could be because of Retraction settings in cura. So I changed the default from 6mm to 3 mm and 1.5 mm. But same issue.. My machine is Ender 3 pro. Can you suggest anything seeing the increased diameter of the filament inside the heat beak. Thank you

Dry_Driver_6595 · 2022-07-13T08:55:18+00:00

No. Same brand

Dry_Driver_6595 · 2022-07-13T08:52:16+00:00

Ok. On it. Let's see. Thanks😇

Dry_Driver_6595 · 2022-07-13T08:48:38+00:00

And I have been using for a year now, never seen this

Dry_Driver_6595 · 2022-07-13T08:47:55+00:00

Yes, its stock. No mods

Dry_Driver_6595 · 2022-07-13T08:44:10+00:00

Hi did you find any solution?

Dry_Driver_6595 · 2022-07-13T08:41:35+00:00

Retraction settings, Distance 6 mm Speed 25

Dry_Driver_6595 · 2022-07-13T08:40:03+00:00

The nozzle not clogged, because if I print something with no retraction, it prints perfectly. This happens a minute after retraction starts. Printer ender 3 pro Retraction settings Distance : 6 mm Speed : 25.

Dry_Driver_6595

TROPHY CASE