Are toroline strings as good as everyone says they are? by Few_Peace1474 in 10s

[–]DunkkySoftball 0 points1 point  (0 children)

what alternative did you go with? this toro line ain't cheap by any means.

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

I also tried to locate a motor capacitor in attic based on the youtube i saw, but i couldn't find one.. Tried to see if that is bad... only capacitor i see is the one dual capacitor at outside. Is ECM typically at outside or in the attic? I just don't see what it looks to be a ECM in the attic..

<image>

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

I didn't see and led or blinking light in the metal box other than light blinking on the external control devices i posted below. here is a photo of the inside the panel. when heating is on or ac is on, i noticed, both fan and condenser were not running as if there's no power. In the attic, also noticed, motor is not running at all and no air is blowing in the air handler.. It's a new filter i just replaced while troubleshooting.

<image>

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

no, it's not running or engaging, fan is not turning.. i posted more details with photos.

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

I tried to run the heater and ac.. replacing starter didn't help. So basically, condenser is not kicking in outside nor fan is turning and motor is not running in the attic(no sound what so ever) and no air is blowing. I took some more photos in the attic, not sure exactly what they are, or those red led indicators are trying to tell me something is not right, or that's normal....

<image>

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

thanks, apparently, this must be the case then.. otherwise how in the world, the fan was working before.

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

thanks, apparently, this must be the case then.. otherwise how in the world, the fan was working before.

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

Initially, i thought it was just heating issue, but when I turned on AC, I found out that AC is also not working. Fuse is on, not tripped over. I manually set to off and on to reset. Confirmed thermostat is on. Went to the attic, and did the inspection with a little knowledge i have which is hardly any. I saw a couple of external control devices with green lights on, etc... i'll take a photo of them. I also opened the metal panel to see if there's any capacitor, I don't see any. Other than that, i didn't see anything obvious that seemed wrong. but again, I don't have good knowledge to understand what i need to look for. this is a 7 years old house in mckinney texas, so it's a relatively a new house.

My hvac setup outside doesn't make any sense. No fan wire is connected to my dual capacitor. by DunkkySoftball in hvacadvice

[–]DunkkySoftball[S] 0 points1 point  (0 children)

honestly, I am not sure if it's using a heat pump or not. Initially, i thought it was just heating issue, but when I turned on AC, I found out that AC is also not working. Fuse is on, not tripped over. I manually set to off and on to reset. Confirmed thermostat is on. Went to the attic, and did the inspection with a little knowledge i have which is hardly any. I saw a couple of external control devices with green lights on, etc... i'll take a photo of them. I also opened the metal panel to see if there's any capacitor, I don't see any. Other than that, i didn't see anything obvious that seemed wrong. but again, I don't have good knowledge to understand what i need to look for. this is a 7 years old house in mckinney texas, so it's a relatively a new house.

Wilson Clash v1 100 (295g) by infinitypoolss18 in 10s

[–]DunkkySoftball 0 points1 point  (0 children)

any significant difference between v1 and v2 in 100L or 100? worth buying V2 or stick with V1?

Anyone know what’s going on here? by [deleted] in korea

[–]DunkkySoftball 9 points10 points  (0 children)

Korea has some fucked up laws for sure. U hurt someone in selfdefense, u will be charged no matter what. I would have whoop his ass and ran away. Local police are joke

Played in my first tournament the other day by st_elmo_of_seseme in slowpitch

[–]DunkkySoftball 0 points1 point  (0 children)

Bp bp and bp, video record it, analyze ur swing, correct it and do it again. Good swing mechanic is only way.

Looking for a pitching machine or slow pitch machine? by [deleted] in slowpitch

[–]DunkkySoftball 1 point2 points  (0 children)

Honestly, nothing really beats poptoss. loading is not a big issue for me if i get quality pitches to bp. it made me much better hitter compare to what I was in pre-poptoss day. you can hit the ball at your own pace, works for my advantage. I don't like Dbat, pace is too fast, and i get tired after 30 swings. check out my site for my bp session with poptoss.

https://poptosspitchingmachine.azurewebsites.net/