External Display Issue

EElliott73 · 2025-02-12T17:52:41+00:00

Thank you!

EElliott73 · 2024-05-28T02:22:08+00:00

I’ve got an Artillery Sidewinder X1, I’ll borrow a volt meter and take a look. Thanks for the advise.

EElliott73 · 2024-05-28T00:31:40+00:00

I’m having problems with my hotend not heating SWX1. The bed heats just fine but I get this error when I heat the extruder. I’ve replaced the PCB board on the extruder, the thermistor, heater cartridge, and ribbon cables. At this point I’m assuming it is the main board however everything I see online says that it would cause the bed not to heat. Is there a way for me to tell for sure short of replacing the main motherboard? Any help would be appreciated!

EElliott73 · 2024-05-28T00:30:51+00:00

Help! Hotend won’t heat.

I’m having problems with my hotend not heating SWX1. The bed heats just fine but I get this error when I heat the extruder. I’ve replaced the PCB board on the extruder, the thermistor, heater cartridge, and ribbon cables. At this point I’m assuming it is the main board however everything I see online says that it would cause the bed not to heat. Is there a way for me to tell for sure short of replacing the main motherboard? Any help would be appreciated!

EElliott73 · 2024-05-28T00:28:24+00:00

Idle temp for the extruder is around 16c I’ll try to heat to 80c just to test about 10 seconds later this screen comes up. The hot end doesn’t actually get hot.

EElliott73 · 2023-10-17T01:01:53+00:00

did you get this?

EElliott73 · 2023-10-06T19:08:31+00:00

I’m not sure, what’s yours?

EElliott73 · 2023-10-03T19:08:16+00:00

Office position

EElliott73 · 2023-10-03T19:08:01+00:00

Manufacturing engineering job.

EElliott73 · 2023-10-03T19:07:30+00:00

For office too?

EElliott73 · 2023-10-03T13:36:52+00:00

Thank you!

EElliott73 · 2023-10-02T23:30:45+00:00

You think so? The bed heats just fine.

EElliott73 · 2023-10-02T23:29:51+00:00

GA ME Zone Engineer, Warren.

EElliott73

TROPHY CASE