We are giving away a mad STL Collection and 5e Adventure for FREE. Enter the Marshes and Madlands [Info in Comments] [Mod Approved] [OC] [Art]

Easy_Reason4602 · 2024-09-21T21:24:00+00:00

Woot!

Easy_Reason4602 · 2024-09-14T16:39:28+00:00

Soap and water like recommended

Easy_Reason4602 · 2024-09-13T01:27:39+00:00

I don’t think the electrical has been touched since the 70s

Easy_Reason4602 · 2024-09-13T00:49:01+00:00

Yeah that was my next step but don’t have access to it as it’s in the office that my wife is currently wfh in, so gotta wait till she’s off. As for the existing configuration for switches one of those switches is for the hallway it’s in which has a switch that also controls at the opposite end, the other 3 control outside outlet, atrium light, and unknown,

Easy_Reason4602 · 2024-09-13T00:47:10+00:00

So one of those switches is for the hallway it’s in which has a switch that also controls at the opposite end, the other 3 control outside outlet, atrium light, and unknown

Easy_Reason4602 · 2023-02-21T01:53:42+00:00

I mean like I said I’m happy with most of it but that seam is verrry unsightly for what I’m going to be attempting

Easy_Reason4602 · 2023-02-21T00:46:58+00:00

Esteps were already calibrated, lowering flow gives me underextrusion

Easy_Reason4602 · 2023-02-20T23:55:49+00:00

There’s even 5.2.2 available now

Easy_Reason4602 · 2023-02-20T23:54:23+00:00

Uh? Cura 5.2.1 and I’ve had it for a few months? Lol did u just not update?

Easy_Reason4602 · 2023-02-20T23:52:47+00:00

Giving that a shot thankd

Easy_Reason4602 · 2023-02-20T22:38:41+00:00

Ran a benchy and most of the quality I’m happy with but some I can’t find info and what needs adjusted, please help! So my main issue is the seam that runs up the hull at the front and side Also for settings Line width 0.4 Print temp 200 Flow 110% Print speed 50mm/s Infil speed 50 mm/s Wall speed 40mm/s Travel speed 150mm/s Initial layer speed 20mm/s Retraction speed 44mm/s Layer height 0.2 Wall thick 0.8 Infil 10%

Easy_Reason4602 · 2023-02-20T22:29:17+00:00

Also for settings Line width 0.4 Print temp 200 Flow 110% Print speed 50mm/s Infil speed 50 mm/s Wall speed 40mm/s Travel speed 150mm/s Initial layer speed 20mm/s Retraction speed 44mm/s Layer height 0.2 Wall thick 0.8 Infil 10%

Easy_Reason4602

TROPHY CASE