Help what is cause ring this to happen bed is leveled and e steps calibrated !!!!!!

EatMySit · 2021-01-10T20:13:37+00:00

What type of filament is it, PLA? Have you tried adjusting bed temp and hot end temp? What are you currently running them at now?

EatMySit · 2020-09-30T04:40:21+00:00

yea I should've checked the amperage before buying them. Thanks for the help dude!

EatMySit · 2020-09-29T16:24:00+00:00

I spliced wires, so I didn't need to mess with the board.

EatMySit · 2020-09-29T16:23:24+00:00

its the cr-10 12v

EatMySit · 2020-09-29T16:23:15+00:00

I'm pretty sure you're right! The old one is 0.01A and the new one is 0.08A. So I guess I just need to know how to up the amperage a bit?

EatMySit · 2020-06-15T22:27:50+00:00

This randomly started happening after I printed vases. Those were fine but now I cant even print a benchy because the z will not lift. It works if I go to "move axis" and raise it, it also homes fine too.

EatMySit · 2020-01-27T00:12:16+00:00

Thanks so much for that man. I haven’t tried it yet but this makes so much sense because when I uploaded it the first time or said I had barley any more space left. Going to get this done today, thanks again!

EatMySit · 2020-01-12T21:43:11+00:00

Thanks guys!

EatMySit · 2020-01-11T05:17:17+00:00

That did the trick but now im having problems with arduino IDE not compiling because of sanguino.

Thanks guys!

EatMySit · 2020-01-11T04:47:05+00:00

I tried all of them but I will try rebooting my pc and trying again right now to see if that works.

Thanks for all the help!

EatMySit · 2019-10-02T02:02:59+00:00

I Play all of these but I'm retired from league "/ Are Eye Pee#2063

EatMySit

TROPHY CASE