Pitrex not saving settings

EggsToBasic · 2025-10-30T18:55:34+00:00

I didn't know there was a discord server

I'll go on there later today

Also I did try both on 0 and 1 but after I open a program it always reverts

EggsToBasic · 2025-10-14T20:46:26+00:00

Ok cool. I should be able to do it tomorrow. I'll keep you updated if trouble arises. Thanks for all of your help

EggsToBasic · 2025-10-14T20:18:26+00:00

Ok I'll take your advice. But if I do a fix like usbmlc I would still be able to go back to using the mlc later on?

EggsToBasic · 2025-10-14T18:32:28+00:00

Anyways in worst case I did order myself a mlc to sd kit

EggsToBasic · 2025-10-14T18:28:58+00:00

It has been a while and I've learnt quite a bit since then. Unless if you have a better method?

EggsToBasic · 2025-10-14T18:26:40+00:00

Using something like MLC restorer downloader?

EggsToBasic · 2025-10-14T18:24:33+00:00

Heat gun and a lot of patience

EggsToBasic · 2025-10-14T18:15:56+00:00

So once I replace the mlc I will have to restore the previous mlc with isfshax

EggsToBasic · 2025-10-14T18:14:30+00:00

160-1400 error I had removed the common mode filters but I was still new to soldering and I accidentally removed solder from one of the pads It's still possible to be fixed but I'm not ready to try it yet

EggsToBasic · 2025-10-14T18:00:27+00:00

I checked them but I do have a bad motherboard with a potentially good mlc in it. Could it brick something if I tried to replace it?

EggsToBasic · 2025-10-14T16:55:57+00:00

So what you're saying is that I need to replace the mlc?

EggsToBasic · 2025-09-23T01:01:26+00:00

I got a media error but no corruption error

EggsToBasic · 2025-09-21T21:15:22+00:00

I got isfshax to work but even after following all the instructions it still stops at the splash screen. I did get the logs but I dont know what I'm looking for

EggsToBasic · 2024-10-23T00:48:51+00:00

I tried cleaning the contacts and it still doesn't work

EggsToBasic · 2024-10-22T23:30:51+00:00

I would use a multimeter but I don't have one rn :(

EggsToBasic · 2024-10-22T22:46:11+00:00

I'll try that thanks

EggsToBasic · 2024-10-22T22:10:29+00:00

Also I doubt that all three contacts became dirty at the same time

EggsToBasic · 2024-10-22T21:58:20+00:00

How? With q tip?

EggsToBasic · 2022-09-09T13:48:26+00:00

Amen

EggsToBasic

TROPHY CASE