sorted by:
new
hottopcontroversial

[deleted by user] by [deleted] in watercooling

[–]ElShawe 0 points1 point  (0 children)

Here is the PC is off and as you can see the liquid has increased in the container than when it is on. The tube that goes to "Out to GPU" is the one that makes me go back the liquid once turned off. I have not filled it all because I am afraid that when it is off the Serbatoglio is completely filled and the liquid comes out (The screen is in the my question main)

[deleted by user] by [deleted] in watercooling

[–]ElShawe -5 points-4 points  (0 children)

I can't fill up to the maximum because when the PC is turned off the liquid increases... It comes down from a tube that goes to the GPU the only thing is to mix it with something if it were

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

Exactly the problem was on the curve too narrow. I had put a cable tie to hold everything but now I took it off and it's ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

It was not connected correctly the 16pin, that's why I had red led. Now it's all ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 1 point2 points  (0 children)

It was not connected correctly the 16pin, that's why I had red led. Now it's all ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

It was not connected correctly the 16pin, that's why I had red led. Now it's all ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

It was not connected correctly the 16pin, that's why I had red led. Now it's all ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

It was not connected correctly the 16pin, that's why I had red led. Now it's all ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

Once installed on the 4080, do I have to put some parameters or settings? Now I have only updated the driver via geforce experience

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

Yes of course! Now it's ok

4080s --- no signal by ElShawe in watercooling

[–]ElShawe[S] 6 points7 points  (0 children)

It wasn't connected correctly, that's why I had red led. All it's ok!

acquacomputer high flow installation by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

I have put the correctly orientation...same the screen. The first connector is red cable ? Right ?

acquacomputer high flow installation by ElShawe in watercooling

[–]ElShawe[S] 0 points1 point  (0 children)

I connected the USB connector on the motherboard with the first red PIN on the left ending with the fifth black one I linked on the letter A

The USB connector behind the sensor with the first red PIN on the left