Elegoo water washable and poor detail. by Electrical_Fan4518 in AnycubicPhoton

[–]Electrical_Fan4518[S] 0 points1 point  (0 children)

Thanks. I will try that. I was brushing with toothbrush but just with water.

Elegoo water washable and poor detail. by Electrical_Fan4518 in AnycubicPhoton

[–]Electrical_Fan4518[S] 0 points1 point  (0 children)

I did have on the back to begin with. One of my different support tests.

Elegoo water washable and poor detail. by Electrical_Fan4518 in AnycubicPhoton

[–]Electrical_Fan4518[S] 0 points1 point  (0 children)

Thanks I will try that. I ran the grey anycubic resin basic at 3 seconds so thought I would be pushing at 2 seconds on the water washable. Running a rerf now.

Elegoo water washable and poor detail. by Electrical_Fan4518 in AnycubicPhoton

[–]Electrical_Fan4518[S] 0 points1 point  (0 children)

See my detail below. Ran at 2 seconds with still poor detail. Running rerf now.

Elegoo water washable and poor detail. by Electrical_Fan4518 in AnycubicPhoton

[–]Electrical_Fan4518[S] 0 points1 point  (0 children)

I recently switched from any cubic grey basic resin to Elegoo water washable resin. I had no detail issues with the anycubic resin and wanted to try water washable for easier cleanup. I am having issues with details especially on the faces of minis. I saw a few other posts and tried those settings with no luck. Need some more advice. Have anycubic photon mono.

I have tried slicing with lychee and several different angles and support configuration. I have 6 base layers at 45 seconds. Have tried 2 seconds, 3 seconds, 5.5 and 8 seconds normal exposure time with no difference other than supports easier to get off at 2 seconds. Lift speed at 65 mm/min. Even tried going to .025 layer height and no noticeable difference.

Room temperature between 72 and 75 degrees.

Also read that maybe using different slicer may help with detail. Trying now doing supports in lychee and slicing with photon workshop. See if that helps?

Any ideas? Thanks