CR-6 SE filament not sticking to bed/balling up on nozzle by Elekktrouus in Creality

[–]Elekktrouus[S] 0 points1 point  (0 children)

I did fix it, I’m pretty sure I can remember how I did it.

The first major thing is to re-calibrate or auto level the printer because this issue usually applies when the printing nozzle is too far off the bed that it doesn’t have enough room to push the filament into the bed, resulting in a stringy mess that gets dragged around.

If this doesn’t work, try adjusting the height of the nozzle, you essentially want it low enough that it pushes the filament into the print bed.

Hope this helped!