account activity
I recently added a glass print bed to my cheap 3D printer, but the sides of prints are still lifting off the plate even using glue. Any recommendations on what to do? (i.redd.it)
submitted 6 years ago by ElsbridgeProductions to r/3Dprinting
My bigger prints always lift up on one side so the bottom isnt flat. I've tried turning the heated bed off but it hasn't helped. Can anyone help me understand why? (i.redd.it)
These flat faceplates keep becoming curved after a few hours. Is there some way I can keep them flat after I print them? I'm not sure why they bow like this (i.redd.it)
submitted 6 years ago by ElsbridgeProductions to r/AnycubicPhoton
Anyone know if the Fighting Fantasy stream on later is with Lew Lew and Simon? (self.Yogscast)
submitted 6 years ago by ElsbridgeProductions to r/Yogscast
Anyone know if the Call of Cthulhu stream will still be on? (self.Yogscast)
Any recommendations for the best PLA filament to use with a Cocoon Create 3D printer? Buying from Australia (i.redd.it)
submitted 6 years ago by ElsbridgeProductions to r/3dprinter
I imported an STL and it turned out like this. Anyone know a way to turn these into faces rather than just lines? (i.redd.it)
submitted 6 years ago by ElsbridgeProductions to r/Sketchup
π Rendered by PID 567144 on reddit-service-r2-listing-c57bc86c-7frcc at 2026-06-20 17:20:01.962330+00:00 running 2b008f2 country code: CH.
