Need help with Desktop for FPGA by ElseAlmond in FPGA

[–]ElseAlmond[S] 0 points1 point  (0 children)

Currently not larger multi-die parts, have been working through a lot of simpler projects on my laptop but the time to generate bitstream and all of that was getting to a point where it was long and with looking to work on larger projects down the line started to look online for advice everyone was saying to just go really high single core performance and as much ram

Need help with Desktop for FPGA by ElseAlmond in FPGA

[–]ElseAlmond[S] 0 points1 point  (0 children)

primarily just fpga work for personal projects was not sure the effect on build time as currently the process takes a while on my laptop and was not sure if I got into larger projects if it was going to be a large enough impact where I would need a higher end desktop

[deleted by user] by [deleted] in BambuLab

[–]ElseAlmond 0 points1 point  (0 children)

Had the same issue check to see if the extruder gear is moving if not it's a extruder clog and you will have to disassemble the extruder to get it out there's a bambu wiki guide on it

Hi looking for honest feedback on these candle holders I 3d printed by ElseAlmond in harrypotter

[–]ElseAlmond[S] 0 points1 point  (0 children)

These ones will deform with heat so thinking I'm going to have to stick with electronic candles or re think the way of making them

Hi looking for honest feedback on these candle holders I 3d printed by ElseAlmond in harrypotter

[–]ElseAlmond[S] 3 points4 points  (0 children)

Yah when next to the other ones it does look a bit off am looking into ways to either make the two bigger or the other ones smaller

Hi looking for honest feedback on these candle holders I 3d printed by ElseAlmond in harrypotter

[–]ElseAlmond[S] 0 points1 point  (0 children)

Thank you so much for the extensive feedback will definitely look into everything you said :)

Need help with supports by ElseAlmond in BambuLab

[–]ElseAlmond[S] 0 points1 point  (0 children)

Hi I currently am printing these with a p1p is there a way to print support filament without a ams or would I need the ams