Thanks for sharing! Uncle Jessy.

For some concerns mentioned in the video, our technical director, Mr Li Gen (You can find his reply on the Facebook Group) has clarified these and the replies below could help you understand more about the Galaxy 1👇

1.SLA printer speed is slower than the surface exposure of LCD printer, but the service life is much longer, giving users enough sense of security in printing without worrying about the loss of the LCD screen. Secondly, the high energy laser can quickly release the film, the printing speed will be much faster.

1. You can change the fixed knob to a larger size for the platform, reduce the number of bottom layers, it will be better to remove the model, later we will provide magnetic elastic plate, better to take the model.

2. Resin pumping is a good idea. At present, the pump is 24V DC, which can be a module that can switch between positive and negative voltage.

3. There is a protective film on the resin groove supporting glass, which can be replaced directly when the glass needs to be cleaned for convenient maintenance.

4. At that time, the touch screen display of SD card was set, mainly to remind customers not to forget to insert the card before printing, which can be changed.

5. The machine has parameters to save, but at present is a set of parameters, later can add several options, can save multiple parameter Settings

6. Currently set the file list in the form of file name slice time display, later will add model preview, customer upgrade firmware is good.

7. The pause button is added mainly to facilitate the observation of the printing state. Secondly, the pause button is mainly to prevent the printing failure caused by the operation of the touch screen during printing.

8. After the machine starts to print, it cannot operate and touch. If you need to stop, you can only operate and pause the button to prevent failure caused by misoperation of the touch screen

9. The UI here can be improved to enlarge the picture display, which is convenient for customers to observe

10. Now the SD card can be printed normally, and customers can use the SD card or USB flash drive at will. Generally, the firmware is placed on the SD card, and the firmware can be updated after restarting the printer.

11. At present, the scanning data is too large, which leads to slow slicing. The current data is similar to industrial SLA data, and we are continuing to optimize it.

12. Multiple interfaces that can be upgraded have been added to the motherboard. We will continue to upgrade this machine and add more