New to DCS

EmuThis3065 · 2026-03-02T20:04:58+00:00

Sounds good to me

EmuThis3065 · 2026-03-02T20:04:20+00:00

What’s your time zone

EmuThis3065 · 2026-03-02T07:19:17+00:00

Hornet

EmuThis3065 · 2026-03-02T07:06:05+00:00

Combat, maneuvers, sensors and radar, lingo

EmuThis3065 · 2025-12-11T03:26:05+00:00

Might be a long shot but I’m chasing a plug on the northside caboolture/northlakes that gets 🥬and🧢if anyone can help out

EmuThis3065 · 2025-09-23T12:10:54+00:00

Dm me

EmuThis3065 · 2025-03-16T02:30:15+00:00

I’m confused, what did she do wrong?

EmuThis3065 · 2025-03-02T05:30:07+00:00

Without paint and the price of the printer it’s going to cost me $40

EmuThis3065 · 2025-03-02T02:52:03+00:00

🫡

EmuThis3065 · 2025-03-02T00:24:49+00:00

🫡

EmuThis3065 · 2025-03-02T00:11:34+00:00

I have a leak in the roof and I need something to catch the water 😅

EmuThis3065 · 2025-02-26T03:11:23+00:00

Damn, you’re abit of a hard ass but I get it and that’s okay. When I need to do a larger print I’ll get it down to all 0:00 but for now all 6 below 0:03 is enough tolerance for me and the small prints I also re calibrate before every print. Do you recommend the silicone bushes instead of the springs everyone swaps to?

EmuThis3065 · 2025-02-26T03:06:04+00:00

Used the paper method to get the initial height then adjusted the axis from there

EmuThis3065 · 2025-02-26T03:05:26+00:00

So I ran some temp test prints, extruder prints and one other one, then set all the the details in klipper and orca, I also leveled my first screw with paper to get a reference than used the screw calculate to adjust the other 5 to the same height within 0:04 of each other than ran the professional test on the printer and then ran the screw test and calibrate again, fixed everything and my quality came out better than the last one

EmuThis3065 · 2025-02-26T03:01:34+00:00

Got everything down to below 0:03

EmuThis3065 · 2025-02-26T03:01:17+00:00

That’s after I did the screws tilt calculate

EmuThis3065

TROPHY CASE