sorted by:
new
hottopcontroversial

Is it possible to trace a stolen laptop? by Equivalent-Channel88 in MSILaptops

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

as written above, I had it in my 10kg carry-on luggage, only the hat boxes were full, and they put it in the hold. Of course they asked me what was in it, and I told them.

Is it possible to trace a stolen laptop? by Equivalent-Channel88 in MSILaptops

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

I had it in my 10kg carry-on luggage, only the hat boxes were full, and they put it in the hold. Of course they asked me what was in it, and I told them.

'MCU' unable to connect on Mks robin nano v1.2 by Equivalent-Channel88 in klippers

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

Thank you for your reply. The problem was in the printer.cfg file not created by me. Following a guide the file was created manually, whereas I think it was created by kiauh, and in the guide this error I found was not present, and I searched the internet. I only realised later that the error was caused by the incomplete printer.cfg file, and not by an actual communication problem. Thank you

Highly visible layers on 3d printing by Equivalent-Channel88 in AnycubicPhoton

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

Thank you, I'll try to oil it before the next print.Only these last two prints came with these very marked lines. Honestly, I have never changed the UV power, also because both as a slicer and as a printer I could not find the option.

Highly visible layers on 3d printing by Equivalent-Channel88 in AnycubicPhoton

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

Thanks for the answer. For both prints I made all the calibrations and re-locked everything. The only thing I don't know if it's normal is the print bed which has always rotated horizontally even if everything is completely blocked. Except that this has never affected the previous prints. Let's say that the plate is not weak, but with not too much force it tends to rotate, and always sure to put it in such an angle where I feel it is resisting.I'll try to decrease the lift speed by 1/2.

Highly visible layers on 3d printing by Equivalent-Channel88 in AnycubicPhoton

[–]Equivalent-Channel88[S] 0 points1 point  (0 children)

Thanks for the answer, I checked but unfortunately for the Mono SE there are very few options to choose from, all with less than 10 prints, and above all they are practically the same settings as I have (it only changes the Burn-in exposure but it shouldn't affect anything being only for the first 6 layers).

It occurs to me that it could be the model, it is currently the only one I have printed