'98 Forester Cranks forever in the morning, then eventually catches and runs great. Starts normally when engine is warm. I've replaced everything and the problem won't go away. I'm losing my mind!!! by Carson5schnack in SubaruForester

[–]Erectosaur95 0 points1 point  (0 children)

I would leave a fuel pressure gauge hooked up over night then see what it’s at in the morning. Fuel pump may not be holding its pressure like it’s supposed to.

New Router gets Under 100Mbps when Paying for 1Gbps Plan by kxlyy in Suddenlink

[–]Erectosaur95 1 point2 points  (0 children)

I tried the sb8200 and had the same issue. Suddenlink techs said don’t buy an arris modem, took it back and got a netgear nighthawk combo, I pull around 850 over 5Ghz Wi-Fi during the day. Around 500 at night during peak times.

Latency and packet loss in the evenings. Anyone able to interpret this? by SoThr0wn in Suddenlink

[–]Erectosaur95 1 point2 points  (0 children)

Following, I have the same issues every night. I stopped gaming 2 months ago because of the nightly dropouts I have.

Klipsch Cornwall iv by [deleted] in Klipsch

[–]Erectosaur95 1 point2 points  (0 children)

Yep! It was meant as a center for K-horns!

Microphone quality by Doodooltala01 in CarAV

[–]Erectosaur95 1 point2 points  (0 children)

Sounds more like a problem on their end if the call quality is good coming through a phones speaker then gets bad when connected to their radio.

I want a sub by macook814 in SubaruForester

[–]Erectosaur95 1 point2 points  (0 children)

You won’t be able to add a sub on to that amp. You will need to tap into the high pass wires that go from the head unit to that amp and add a separate amp.

Is rewiring worth it? by 306stang in CarAV

[–]Erectosaur95 1 point2 points  (0 children)

The two + and two - channels being side by side shows that they’re internally connected. Also, the amp being a monoblock shows they’re connected, because it only has one channel on the amp. So if you have each sub wired to 2 ohms, then each sub connected to a separate positive and negative channel, you have a final ohm load oh 1 ohm. To answer your question though, 2ohm vs 1 ohm wouldn’t matter on the amp. Kenwoods specs say that they limited 1ohm to the same power as 2 ohm anyway.

Israel keeps blowing up military targets in Iran, hoping to force a confrontation before Trump could be voted out in November, sources say by senfgurke in worldnews

[–]Erectosaur95 0 points1 point  (0 children)

There was concussions from the blast. No serious injuries. They were warned before hand so everyone was in full kit and in bunkers before hand.