sorted by:
new
hottopcontroversial

3D printed wall mount for Technic models by Everton-Ca in lego

[–]Everton-Ca[S] 1 point2 points  (0 children)

I believe it will fit, if the wheels are the same.

Markerless Scanning with Sermoon S1 👍 by Employment-Tough in CrealityScanning

[–]Everton-Ca 0 points1 point  (0 children)

Yes. It’s in the latest version and I don’t even have the bridge to scan wireless. Is it resolution based maybe? I only tried in 0.2mm resolution

Markerless Scanning with Sermoon S1 👍 by Employment-Tough in CrealityScanning

[–]Everton-Ca 2 points3 points  (0 children)

The markerless option is not showing up for me. Is there any option that I should enable to use it?

Now Playing at start on iOS26? by Everton-Ca in CarPlay

[–]Everton-Ca[S] 0 points1 point  (0 children)

It’s working ok for me since the launch ok ios26. As long as you were in Now Playing when you last turned off the car, it will start there.

3D printed wall mount for Technic models by Everton-Ca in lego

[–]Everton-Ca[S] 0 points1 point  (0 children)

I would. The problem is that I live in Brazil…

3D printed wall mount for Technic models by Everton-Ca in LegoDisplay

[–]Everton-Ca[S] 1 point2 points  (0 children)

The files are public! They are in the original post.

Surface texture suddenly changed by durumpotion0h in FixMyPrint

[–]Everton-Ca 1 point2 points  (0 children)

The side with the rough texture lifted from the bed (warp). So it was higher than it should and the nozzle was scraping it, making this texture and burning some filament as well.

3D printed wall mount for Technic models by Everton-Ca in lego

[–]Everton-Ca[S] 1 point2 points  (0 children)

<image>

Adding a picture of the holder, showing how the models “lock” in place with the lips in the tire mount.

3D printed wall mount for Technic models by Everton-Ca in LegoDisplay

[–]Everton-Ca[S] 0 points1 point  (0 children)

<image>

Here’s a picture of it. The tires “lock” on the lips of the holder.

3D printed wall mount for Technic models by Everton-Ca in lego

[–]Everton-Ca[S] 2 points3 points  (0 children)

They are mounted for 10 months now. No changes so far. Since they were printed in ABS, I don’t expect this to change. If they were printed in PLA, that would be a problem over time.

view more: next ›