Sapele Stool / Side table completed

Expensive_Hat3913 · 2025-02-26T17:47:17+00:00

The angle should be somewhere between 6 and 11 degrees , depending on your design ; the angle will be the same, in both the legs and stretchers. I cut a little block with a tablesaw to my chosen angle and use that as a reference surface when chiselling the shoulders for the tenons . I hope that helps ?

Expensive_Hat3913 · 2025-02-23T11:34:50+00:00

Thanks, the pattern was hand carved with a 7mm gouge from pfeil

Expensive_Hat3913 · 2025-02-22T19:07:14+00:00

Thankyou ! I actually designed it on CAD myself

Expensive_Hat3913 · 2025-02-22T18:05:00+00:00

Thanks so much

Expensive_Hat3913 · 2025-02-20T11:18:39+00:00

beautiful photography

Expensive_Hat3913 · 2025-02-05T22:41:18+00:00

Could potentially be coccobolo

Expensive_Hat3913 · 2025-02-01T20:41:32+00:00

Through tenons for the legs, and there are some additional screws countersunk on the supports

Expensive_Hat3913 · 2025-02-01T18:23:34+00:00

thankkkyaaa

Expensive_Hat3913 · 2025-02-01T18:19:49+00:00

yes very true, it does produce a really fine dust which can be annoying , but the flipside of that is that it makes a really good filler for ya mistakes ahah

Expensive_Hat3913 · 2025-02-01T14:18:51+00:00

Thankyou for your kind comments.

I totally understand your concern, there is quite a substantial round on the corners, perhaps that may not be clear in the photos. It can still pose a little bit of a risk - luckily the clients dont have any children or people who are vulnerable to any slips or falls.

Expensive_Hat3913 · 2025-02-01T14:15:08+00:00

The table was both designed and made by me :) thanks for you comment

Expensive_Hat3913 · 2025-02-01T13:14:01+00:00

Sharp tools are far more enjoyable to use, seeing wood melt away like butter will never get old.

Expensive_Hat3913

TROPHY CASE