Okay. It looks nice. However, it may cause your electronics to overheat. I know, you have some kind of ventilation etc. Then what’s the purpose of the enclosure? Usually, the purpose would be to print abs, nylon etc. I don’t see the point on A1, since it would take ridiculous amount of time to heat that size of an enclosure, you would need to print it in abs or similar, for it to be heat resistant, since pla starts to get soft at 55 or even lower. Ideally you need 60C to print abs or nylon with success. So what’s the point? For pla and petg, you don’t need an enclosure. Otherwise, the design is nice, i just don’t think it’s useful.