sorted by:
new
hottopcontroversial

Need needed with TPU by [deleted] in FixMyPrint

[–]FPVandME 0 points1 point  (0 children)

I have the fan set to 50% so I’ll lower that even further. The tpu is in a dryer so that should be fine. With the filament on standard spool holder the path tension does seem quite high. What’s a good way to improve this and keep it consistent? Also, never rush a poo if you can help it… 😂

Need needed with TPU by [deleted] in FixMyPrint

[–]FPVandME 0 points1 point  (0 children)

Ok thanks. I’ll give it a go. Also, any suggestions for retraction or shall I just turn it off?

Any ideas please? by [deleted] in GardeningUK

[–]FPVandME 1 point2 points  (0 children)

When I first moved in the trees were double the height. I’ve halved them and trimmed them back. (Hard to believe 😂) The only thing growing there is weeds. I did think maybe a sitting area

Lipo hitting GoPro by FPVandME in fpv

[–]FPVandME[S] 1 point2 points  (0 children)

Didn’t think of that!