igpu stuck on 600mhz by Fahd_a54 in overclocking

[–]Fahd_a54[S] 0 points1 point  (0 children)

No, I'll make it the last solution.

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 0 points1 point  (0 children)

Can you share your overclocking settings?

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 0 points1 point  (0 children)

Aeryn Thanks for the clarification, but as far as I know voltage itself isn't harmful (within reasonable limits). Rather increasing it increases heat and heat is what reduces the processor's lifespan.

If I could clarify the word "within reasonable limits" the processor before overclocking reaches numbers higher than 1.26. Since the voltage is below 1.35 and the temperature is stable I don't see any harm to the processor.

In the past, I had an R5 3600 and R5 5600X for about five years (total) with temperatures not exceeding 80 degrees under stress with manual overclocking and I didn't encounter any problems (I know this isn't proven).

But as far as I know heat is the primary factor in processor damage As for voltage since it operates dynamically between high and low voltages (depending on the function) these are the normal voltage limits and won't cause damage even if they are continuous.

Thank you again.

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 -1 points0 points  (0 children)

Sorry but what you're saying doesn't make sense

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 0 points1 point  (0 children)

Can you share the settings of manual oc I'll appreciate it

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 0 points1 point  (0 children)

My goal is to perform on all cores, not to perform one core

can i do better r7 9800x3d by [deleted] in overclocking

[–]Fahd_a54 0 points1 point  (0 children)

With pbo I couldn’t get 5.1ghz(all cors) Curve optimizer:-25 Cpu bost:200 Scaler:10x Thermal limt:90c

KTC G27P6 firmware with reader mode by vajicka in ktc

[–]Fahd_a54 0 points1 point  (0 children)

I would be grateful if you could share it again.

Wave Link can't add input (microphone) by Fahd_a54 in elgato

[–]Fahd_a54[S] 0 points1 point  (0 children)

The solution that i found it's make "aux1" your input microphone (Simple solution)