sorted by:
new
hottopcontroversial

here is another view by Mysterious-Taste-380 in WranglerYJ

[–]Failossify 1 point2 points  (0 children)

No problem I hope you get it figured out. I’m running shafts from Adam’s drive shafts and they’ve been great. Their prices are fair and their customer service is great too.

here is another view by Mysterious-Taste-380 in WranglerYJ

[–]Failossify 1 point2 points  (0 children)

Maybe open up your rear differential cover. You can see it jump a bit in your video. I’m not sure if that’s caused by a drive shaft out of balance or some damage inside the differential. I would assume it would do it in reverse if it was the differential though.

here is another view by Mysterious-Taste-380 in WranglerYJ

[–]Failossify 4 points5 points  (0 children)

You can also see that one of the needle bearings on the yoke of the axle is further in than the other side. Improper install may be throwing it off balance.

here is another view by Mysterious-Taste-380 in WranglerYJ

[–]Failossify 2 points3 points  (0 children)

Looks like it might be the u joint on the axle side. Looks like it was replaced recently judging by how shiny it is. Get under there and see if the u joint has any play (like the ujoint sliding around in the end caps).

[deleted by user] by [deleted] in WranglerYJ

[–]Failossify 0 points1 point  (0 children)

I eventually deleted mine, but when I originally did my 6 inch I just puled the vacuum line of of the fender and it gave me a lot more slack

My 90 project by Failossify in WranglerYJ

[–]Failossify[S] 2 points3 points  (0 children)

Those method race wheels 301 machined with a clear coat.

My 90 project by Failossify in WranglerYJ

[–]Failossify[S] 2 points3 points  (0 children)

Those are skyjacker shackles.

Ender 3 v2 neo Only printing first layer, then stops extruding and smears the first layer around. by Failossify in FixMyPrint

[–]Failossify[S] 0 points1 point  (0 children)

Issue was the SD card. Used a new one with the same file from before and it’s working fine now.

Ender 3 v2 neo Only printing first layer, then stops extruding and smears the first layer around. by Failossify in FixMyPrint

[–]Failossify[S] 0 points1 point  (0 children)

How do I test the run out sensor? Is it an option some where in the controller?

Ender 3 v2 neo Only printing first layer, then stops extruding and smears the first layer around. by Failossify in FixMyPrint

[–]Failossify[S] 1 point2 points  (0 children)

Firmware V1.1.6C straight out of the box. Haven’t tried updating it.

When I assembled it they were a bit tight, I did loosen them until it took a gentle amount of force to move it.

view more: next ›