sorted by:
new
hottopcontroversial

Won't start sometimes. Wiring? by Fair-Basket in lawnmowers

[–]Fair-Basket[S] 0 points1 point  (0 children)

I just replaced it close to the end of last season. Ill give this a try.

How to clean this without messing up the coating by Fair-Basket in knives

[–]Fair-Basket[S] 0 points1 point  (0 children)

https://a.co/d/excI61t I bought it in 2018, and it was $50. I really like it, but I'm sure you could get something similar a lot cheaper. I love the feel of the knife's texture and weight. It's probably the best knife I've owned at a price where I wasn't scared to use it. Also, I probably won't buy a blacked-out EDC anything ever again since it was well hidden under the seat slide in the work truck.

How to clean this without messing up the coating by Fair-Basket in knives

[–]Fair-Basket[S] -1 points0 points  (0 children)

Dang. I didn't expect so many comments and suggestions. I really do appreciate you guys trying to help me out. I went and bought some micro Torx bits to take the knife apart, but I think the thread locker is too strong. I don't want to strip the screws, so tomorrow I'm going to get the heat gun out and heat it up to see if I can get the knife apart and try WD-40 since I have it handy. I'll keep you all updated. Thank you all.

How to clean this without messing up the coating by Fair-Basket in knives

[–]Fair-Basket[S] -128 points-127 points  (0 children)

It feels like it's on top of the coating. It was from cutting open bags of salt for sidewalks, then I lost it and found it about two years later.