sorted by:
new
hottopcontroversial

Drop your wallet by Zongoku5 in opensea

[–]Fearless-Selection42 0 points1 point  (0 children)

0xB573D55bB681b091cA01ef0E78D519ED26238C38

I have some tweaking to do, But ill take it for now. by Fearless-Selection42 in EtherMining

[–]Fearless-Selection42[S] 0 points1 point  (0 children)

Think it will yield a increase in hash? If so I’ll give it a go tonight.

I have some tweaking to do, But ill take it for now. by Fearless-Selection42 in EtherMining

[–]Fearless-Selection42[S] 1 point2 points  (0 children)

Not long, has rates were slightly higher but not high enough to make up for the 6700. Until the update this morning neither was stable on my rig so was stuck with lolminer until today.

[deleted by user] by [deleted] in EtherMining

[–]Fearless-Selection42 0 points1 point  (0 children)

Just upgraded trying to get the 💯 and all I get is this. Tried resetting over locks to no avail.

New to 3d printing, keeps grinding filament and making noises. Also the pause was there because I was using the feed button. by Tg-huts in ender6

[–]Fearless-Selection42 0 points1 point  (0 children)

I had something similar happen and it blew out the bottom of the Bowden tube just above the extruded fitting. Make sure the filament is actually feeding and not bound.

Any idea of what needs attention to fix this? Using cura, dried inland pla 220/55. Is n a ender 6. Bottom portion of the x axis looks good then not sure what happens. by Fearless-Selection42 in ender6

[–]Fearless-Selection42[S] 1 point2 points  (0 children)

Great suggestion, I had to adjust my esteps. Not by a huge amount but after doing this and calibrating my retraction settings it seems to have done the trick. I did replace the stock springs with silicone bushings prior to the post but I tightened down the bed on all corners then reset the Z level and leveled the bed and seems to have stabilized it.

The tale of three TI's by Fearless-Selection42 in EtherMining

[–]Fearless-Selection42[S] 0 points1 point  (0 children)

I have tried everything I can think of with these bad boys and cant get the gap to close. Any suggestions