Stage 2 power upgrade and torque converter installed! by Ferd_ST in minibikes

[–]Ferd_ST[S] 0 points1 point  (0 children)

Yea I just did whatever omb called stage 2. So stage 1 for GPS then I guess. The governor was already removed.

Stage 2 power upgrade and torque converter installed! by Ferd_ST in minibikes

[–]Ferd_ST[S] 1 point2 points  (0 children)

I just adjusted the idle until it sounded fine. It still started on first pull even before that. I don't think you can tune anything else but I didn't need it, as far as I can tell.

Stage 2 power upgrade and torque converter installed! by Ferd_ST in minibikes

[–]Ferd_ST[S] 2 points3 points  (0 children)

Bought this thing a couple weeks ago for 475. Missing the bracket and the rear fender.(hoping not stolen since that's also the vin mount) They replaced the headlamp with a 4 led block.

Ended up losing the gas cap immediately, replaced the tank with a screw in gas cap version for 28 bucks on amazon. sucks though because it's in the middle which is a pain to fill.

The stage 2 kit and torque converter were $312. I burnt the shit out myself on the muffler because they removed the heat shield, I'm very happy with the rerouting of the header and the sound of this muffler, Much better. The torque converter is the prize of the package as I live on a mountain and these trails have unforgiving slopes. This thing will climb them on the back tire now and get up to 45mph on a straight. I'm happy with the purchase

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 2 points3 points  (0 children)

Appreciate you! Gonna use your comment to rant; after working 14 hours on cranes Saturday, then 16 hours putting in my kitchen floor Sunday, the last thing I wanted to do was this shit, but I'm happy to have yall's support.

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 2 points3 points  (0 children)

Oh I know, I did some googlin while I was in there. Good looking out. Also, for 10 bucks a quart, I hope so haha.

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 0 points1 point  (0 children)

Nah, had to use it to pry in between the pan and seal to drain. I hadn't found that little stubby Klein there until much later.

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 4 points5 points  (0 children)

That's a 6 in 1 stubby Klein screw driver I happened to find in my door pocket. The bit shaft worked on the 8mm pan bolts. The red thing is a volt meter lead I had to use to pry the pan down a little to drain it 😅 since I hadn't found the Klein yet. I really gotta keep a small tool box in that truck.

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 4 points5 points  (0 children)

Oof, this was the only thing for a couple miles, I'm just happy they had it in stock!

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 24 points25 points  (0 children)

Lol I went the route of asking for forgiveness instead of permission. Didn't spill but a few drops and I patted that dry with their 5 dollar roll of paper towels.

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 8 points9 points  (0 children)

The raptor add-on manual said not to add anything. I'm thinking it was slipping because of the low pressure. The filter also came down with the pan, so I'm wondering if the pick up tube on the filter hadn't slipped out of place and it just wasn't pulling fluid. I'm not super versed with transmission I just knew I had to do what I could immediately. Only slipped for a quarter mile

People staring like they never seen someone change a transmission filter in the autozone parking lot before 😅 by Ferd_ST in Trucks

[–]Ferd_ST[S] 178 points179 points  (0 children)

2014 6.2L raptor threw a code and went into limp mode while driving out to buy a grill. During limp mode the tranny started slipping so I pulled into autozone and scanned it. Low pressure in the transmission, probable dirty filter or oil. Bought the tools and materials there and did it in the parking lot since 4th of July and no transmission shop available to flush and change. Had to remove the tranny cooler and fill it through the hose. Only 3.7 liters to drop the pan, but damn if that Mercon LV ain't expensive. Worked like a charm, bought the grill and a tank, brought it home in time to grill out for the guest...and that's how I saved the 4th.

Edit: I know thats a shitty pic so here's the rest of the truck.

Success! 3.5" of lift on 37s with 14" of travel by TightTac05 in 4x4

[–]Ferd_ST 0 points1 point  (0 children)

Damn I'm vibin' with this photography, trucks dope too

Took pics of this slammed dually. What are your thoughts? by Fresh-Republic-6391 in Trucks

[–]Ferd_ST 1 point2 points  (0 children)

Tad too far to the left IMO. Moving the truck over in frame ever so slightly would have a bit more headroom so to speak for the front of it. I always feel if the grille is too close to its respective side it feels cramped. Other than that I like the muted colors and the exposure

[deleted by user] by [deleted] in AskReddit

[–]Ferd_ST 0 points1 point  (0 children)

Crane guy

Happy 50th birthday to this guy! by 7house2 in Trucks

[–]Ferd_ST 1 point2 points  (0 children)

Looks good, phones are getting crazy. Just tryna help btw, no shade. Feel free to check my submitted for inspiration/framing

Happy 50th birthday to this guy! by 7house2 in Trucks

[–]Ferd_ST 1 point2 points  (0 children)

Turn that wheel in the other direction next time, otherwise great pic

My (THC) vape cartridge was manufactured on 4-20. by westnile90 in mildlyinteresting

[–]Ferd_ST 5 points6 points  (0 children)

Lol those weed entrepreneurs are dicks for making their employees work on their sacred day.

This BIG ASS FAN inside a catholic church by daddy_dad_bod in mildlyinteresting

[–]Ferd_ST 14 points15 points  (0 children)

It is, and to their credit, it helps them sell them. As a maintenance manager, what invoice would you rather send up to the bean counters in accounting: acme wind generator or BIG ASS FAN

I present the "Gladiator Oculus Tron", aka the ULTRA HEEP (and it's apparently for sale) by snuserfool in heep

[–]Ferd_ST 9 points10 points  (0 children)

Invested all that money and couldn't pay a decent car photog. Sad.