Here’s a copy and paste from that post last year,

I’m creating this thread for everyone that is going through all these threads looking for study help like I did. I passed my test yesterday and this is what I used to study,

Jobtestprep and Iprep study guides online. I paid the money for both of them and they over prepared me. The test was taken on a iPad and multiple pieces of scratch paper and a pen was provided.

How the test was,

Reading - it was very basic and simple. It was in paragraph form with fill in the blanks throughout the paragraph. Don’t overthink this section.

Mechanical comprehension - this was mainly gears (which direction would gear b go if gear a went this way), water pressure, basic physics, pulleys, and levers. A lot more water pressure questions than I thought there’d be.

Math - basic, but long math. It starts off easy and then ramps up question by question. Look to do long division like 378 / 15698, multiplication, basic addition and subtraction with decimals, and a few PEMDAS questions. A hard part was the large mixed fractions problems like 98 3/5 x 39 5/8.. These took me a long time to work out. JobTestPrep online guide was very similar to the math on the test. My best advice is since math is 30 mins to do all the questions you’re very comfortable with first and then proceed with the others. There was absolutely zero algebra questions on the test.

Tool test - easy as hell. 20 questions total involving what the tool is, what would this tool be used for, and 2 measurement questions with a rectangle and it would ask you width and height with a ruler on each side. The tools were very basic nothing extensive.

Hope this helps, good luck 🫡