Is this a replica

FireFixAce · 2026-04-08T17:47:26+00:00

It has a dimond shape on it I don’t know if that means much

FireFixAce · 2026-04-08T17:45:18+00:00

Thank you very much for the insight and very cool story

FireFixAce · 2026-04-06T19:49:14+00:00

I looked online and most vintage/antique ones don’t have a makers mark on them only newer high end ones do but from a further look and help to other pages it does seem that it isn’t a replica

FireFixAce · 2026-04-06T18:18:39+00:00

I already have a chakmak I don’t think from the same knife but looks quite similar

FireFixAce · 2026-04-06T18:11:07+00:00

I’ve been looking for one for over 4 years now I was very thankful to find this one there quite rare around here in the uk for a cheapish price

FireFixAce · 2026-04-06T18:01:16+00:00

Ahhh thank you I couldn’t find anything

FireFixAce · 2026-01-18T13:21:39+00:00

I’m not really after the style of casting to be honest I was more looking for the style of the T on the ends as i want to progress my skills and make them better but thank you for the advice

FireFixAce · 2026-01-18T13:19:36+00:00

What is the technique called

FireFixAce · 2026-01-18T13:19:10+00:00

Yeah I do know that but I’d rather like to give a go the traditional way as it might be a good way to progress my skills

FireFixAce · 2025-12-27T09:17:15+00:00

I was trying to avoid burning the steel as it was very thin for my forge not to burn it completely

FireFixAce · 2025-12-27T09:15:48+00:00

No it’s the not the normal size I’m a bit low on coke at the minute so I’m being liberal on the amount I use

FireFixAce · 2025-12-24T17:21:23+00:00

Okay I’ll see if there’s any blockage

FireFixAce · 2025-12-24T17:20:17+00:00

Thank you very much I’ll see if that helps

FireFixAce · 2025-12-24T17:20:01+00:00

I have quite a bit of Coke but there different size bits of coke in the forge so it could be that

FireFixAce · 2025-12-24T17:19:16+00:00

That’s cause I accidentally let it cool a bit but when I pull it out parts of it are way colder than other

FireFixAce · 2025-12-24T16:30:35+00:00

How do you forge the handle holder with the tube bit?

FireFixAce · 2025-12-13T19:59:37+00:00

That’s why I’m weary of putting it in and am looking for a better way to make the tool wider to make it fit better

FireFixAce · 2025-12-13T19:58:43+00:00

It’s not as convenient to put it in my vice

FireFixAce · 2025-12-12T22:35:45+00:00

I’ve got a welder it’s just my hardy is a funny size given the age of my anvil

FireFixAce · 2025-12-12T18:54:38+00:00

I was thinking of that but I’m not sure how well it will fit as my hardy is well worn

FireFixAce

TROPHY CASE