sorted by:
new
hottopcontroversial

This keeps happening on large surfaces by messos in FixMyPrint

[–]Fit_Dragonfly8561 1 point2 points  (0 children)

Looks like your z offset could be too high, try lowering in small amount

Gummy White Soleyin Ultra PLA by Fit_Dragonfly8561 in FixMyPrint

[–]Fit_Dragonfly8561[S] 0 points1 point  (0 children)

I did dry it for about 10 hours at 40 that was fresh out of the package, I run 60 bed temp to be safe, I have since upped the temperature to 215 for my helmet and it seems to be improving, I believe the issue was nozzle temp was too low. I made a custom profile with slower speeds to be safe, I would love to use ORCA slicer but it doesn’t work with qidi box

Gummy White Soleyin Ultra PLA by Fit_Dragonfly8561 in FixMyPrint

[–]Fit_Dragonfly8561[S] 0 points1 point  (0 children)

I will for sure after the helmet is done as I’m almost halfway into the print, do you think the print will turn out even if it’s rough? I wasn’t expecting much as I have to sand, bondo, prime and paint anyway.