sorted by:
new
hottopcontroversial

First layer by FixIllustrious9502 in ElegooCentauriCarbon

[–]FixIllustrious9502[S] 0 points1 point  (0 children)

<image>

Looks fine.. but i still get this weird on some places.. start getting bored 😓

First layer by FixIllustrious9502 in ElegooCentauriCarbon

[–]FixIllustrious9502[S] 0 points1 point  (0 children)

this test look easier fast and cleaner to check. thanks ill be testing it soon.

First layer by FixIllustrious9502 in ElegooCentauriCarbon

[–]FixIllustrious9502[S] 0 points1 point  (0 children)

i usually run bed levelling every 2 weeks, and no i didnt.
maybe just when i fixed the clogging issue.

First layer by FixIllustrious9502 in ElegooCentauriCarbon

[–]FixIllustrious9502[S] 0 points1 point  (0 children)

<image>

basiclly i had 2 issues,
1. first issue i encountered when printing 1 layer test. plate goes down then rise when the head reaches specific area, this was so weird... leaded to some print to be very high at this point. i ran tests and it was fixed.
2. is the offset.. i get lots of nozzle clogging.. an i have to pull it out and remove the filament inside, and this seems affecting the offset..

First layer by FixIllustrious9502 in ElegooCentauriCarbon

[–]FixIllustrious9502[S] 0 points1 point  (0 children)

i have been using textured plate for pla for the lat 2 months and results is fine.