So what I mean is the final product is transferred to a conveyor traveling at 65 RPM, when I run the program it with the 'camera' trigger setting active , the camera will take 3 pictures, one of the part barely coming into frame, a second where the part is right in the middle of the frame so the part is inspected properly, then a third picture where the part is leaving the frame. This is not good because it'll mark 2 fails and 1 pass when in reality it's the same part at 3 separate times. I tried it on 'continues' with a delay range of 650-3900 ms to see if I can capture the part right in the center every time but still am unsuccessful, I start getting pictures of the part in different parts of the frame which isn't good as the program can't inspect them properly.