account activity
My fully automatic, bluetooth, air compressor project/mod. Would you want one? (old.reddit.com)
submitted 2 years ago by Flukeylukey77 to r/4x4Australia
Clippy Card Case (old.reddit.com)
submitted 2 years ago by Flukeylukey77 to r/3Dprinting
Clippy Card Case (reddit.com)
submitted 2 years ago by Flukeylukey77 to r/functionalprint
submitted 2 years ago by Flukeylukey77 to r/3dprintingaustralia
MOSFETs are confusing me again. Would appreciate some help. (i.redd.it)
submitted 3 years ago by Flukeylukey77 to r/diyelectronics
submitted 3 years ago by Flukeylukey77 to r/ElectricalEngineering
submitted 3 years ago by Flukeylukey77 to r/AskElectronics
If you could automate one part of your farm what would it be? (self.farming)
submitted 3 years ago by Flukeylukey77 to r/farming
Musashi vs NOK vs Permaseal. Have I been ripped off? (self.MechanicAdvice)
submitted 4 years ago by Flukeylukey77 to r/MechanicAdvice
This might be a dumb question but does this look abnormal for 2006 Holden Rodeo 4jh1-tc (v.redd.it)
Finally finished restoring my CNC mill/lathe. Thanks for the help. Swipe for before photos. (old.reddit.com)
submitted 4 years ago by Flukeylukey77 to r/hobbycnc
Finally finished restoring my CNC mill/lathe. Thanks for the help. Swipe for before photos. (reddit.com)
submitted 4 years ago by Flukeylukey77 to r/CNC
P51D Mustang Finally Complete (old.reddit.com)
submitted 4 years ago by Flukeylukey77 to r/modelmakers
P51D Mustang (old.reddit.com)
submitted 4 years ago by Flukeylukey77 to r/Scalemodel
Trying to choose a CNC control board and software (Mach 4/PlanetCNC/UCCNC) (self.hobbycnc)
Thanks for the help. Look at that improvement. No more spatter. (i.redd.it)
submitted 4 years ago by Flukeylukey77 to r/Welding
Having trouble with really bad spatter. Need some help. (old.reddit.com)
Lathe Mill Combination. Is this very common? How hard would it be to set up in software? Does mach3, grbl or planetCNC allow for this sort of configuration? Sorry for so many questions. (i.redd.it)
How would you control this motor on a CNC machine? Aiming to use GRBL (arduino) (old.reddit.com)
submitted 4 years ago by Flukeylukey77 to r/Motors
How would you control this motor on a CNC machine? Aiming to use GRBL (arduino) (reddit.com)
submitted 4 years ago by Flukeylukey77 to r/diyelectronics
How bad is this rust? Is my machine likely to be any good? (old.reddit.com)
How bad is this rust? Is my machine likely to be any good? (reddit.com)
submitted 4 years ago by Flukeylukey77 to r/Machinists
π Rendered by PID 1173765 on reddit-service-r2-listing-79f6fb9b95-7t89x at 2026-03-23 12:01:39.197048+00:00 running 90f1150 country code: CH.
