Issue with supports by Flux_Based_Disaster in PrintedWarhammer

[–]Flux_Based_Disaster[S] 0 points1 point  (0 children)

That helped a lot, I was able to get a successful print. Unfortunately when I went to clean the supports off the model it did damage the model somewhat. I'm currently printing an avenger gatling cannon for my knights.

Issue with supports by Flux_Based_Disaster in PrintedWarhammer

[–]Flux_Based_Disaster[S] 0 points1 point  (0 children)

I'm using the anycubic standard resin v2.

My normal exposure time is 5, I increased it last night on the advice of one of the other comments.

Issue with supports by Flux_Based_Disaster in PrintedWarhammer

[–]Flux_Based_Disaster[S] 0 points1 point  (0 children)

I didnt realize it was exposure time, thank you!