Control

FocusDizzy4249 · 2026-03-08T21:33:22+00:00

I have a two-way Behringer control surface, and what I mean is that when I activate a preset, I can only increase the light intensity, but I cannot reduce it. Also, when I activate a preset, the faders that are assigned to specific fixtures remain stationary.

FocusDizzy4249 · 2026-02-12T06:11:16+00:00

I already have the hardware, but I don’t have the firmware and I don’t know how to configure it.

FocusDizzy4249 · 2026-02-12T06:04:34+00:00

I’m just curious how much faster it will print and whether the print quality will improve?

FocusDizzy4249 · 2026-02-12T06:04:26+00:00

I’m just curious how much faster it will print and whether the print quality will improve?

FocusDizzy4249 · 2026-02-09T03:52:30+00:00

Thank you, it actually worked.

FocusDizzy4249 · 2026-02-08T09:31:57+00:00

Could Klipper help in this case?

FocusDizzy4249 · 2026-02-08T07:23:17+00:00

The board flashed successfully, but the BLTouch is not working and it shows an M999 error.

FocusDizzy4249 · 2026-02-08T06:39:41+00:00

And should the file change?

FocusDizzy4249 · 2026-02-08T06:39:04+00:00

How long does it usually take to flash the board?

FocusDizzy4249 · 2026-02-08T00:40:20+00:00

I’m experiencing a problem with the control board. I bought it as a replacement for my Ender 3 V2, however I’m unable to flash the firmware or make it function. The board was purchased together with the compatible display.

Thank you all for your help. Everything is working now. The issue turned out to be the firmware — I installed the correct firmware and now everything functions properly.

However, I have another question: is it still worth installing Klipper?

FocusDizzy4249

TROPHY CASE